SureSeal/SuperSeal |
Complete aluminum glazing system with
EPDM gaskets & fasteners |
Perimeter |
Glazing extrusion designed to accept
glazing on one side |
Thermal Break Perimeter |
Perimeter extrusions thermally broken
from exterior to interior |
Intermediate |
Glazing extrusion designed to hold glazing
on both sides |
Low Profile Intermediate |
Sloped application horizontal purlins
with glazing above and below |
Regular Cap |
Cap with SPDM gaskets |
Bevel Cap |
Cap with 1/16” glazing tape for
use over low profile intermediates and over bottom perimeter for
low slope applications |
SureSeal Trim |
Trim that goes in both Regular and Bevel
Cap |
Gaskets |
EPDM gaskets to support and seal the
glazing. Regular gasket is supplied for 1” or 5/8” glazing.
Thicker gaskets are available at additional cost for use with thinner
glazing such as 1/4”. |
T-Bar |
Aluminum extrusions cut to 2” for
glazing panel support |
Setting Blocks |
EPDM or Neoprene rubber blocks for support
of glass |
Silicone or Urethane Sealant |
For sealing of metal and gasket junctions |
Touch-up Paint |
To match extrusion color |
Solvent |
For cleaning metal and glass prior to
sealant application |
Aluminum Sheet,
.040” or .032” |
For fabrication of flashing |
Nails, screws, pop rivets |
For attaching flashing |
Power Miter Box |
To cut aluminum extrusions |
Saw Blade |
60 or 80 tooth non-ferrous metals carbide
tipped blade |
Hand Electric Drill or Drillpress |
For drilling mounting and weep holes
in SureSeal extrusions |
Drill Bits |
1/4” for base and cap screws, 1/8” & 3/16” for
weep holes |
Cordless Drill w/clutch |
For tightening base and cap screws |
Hex driver sockets/bits |
To use with clutch drill to tighten hex
head screws |
Caulking Gun |
For sealant application |
Rubber or plastic mallet |
For trim strip application |
Tin Snips |
For cutting flashing |
Pop rivet tool |
To fasten pop rivets |
Safety Goggles |
For personal protection while cutting & drilling
metal |
Ear Protectors |
For personal protection while cutting & drilling
metal |